Troubleshooting Guide

Variable definitions
Use the data in the following table to use the show ip igmp group command.
Variable Value
count Displays the number of entries in the IGMP group.
group <A.B.C.D> Specifies the address of the IGMP group.
member-subnet {default| <A.B.C.D>}] Specifies the IP address and mask of the IGMP member.
vrf WORD<1–16> Specifies the VRF name.
vrfids WORD<0–512> Specifies the VRF ID.
Use the data in the following table to use the show ip igmp group group command.
Variable Value
detail [port {slot/port[/sub-port][-slot/port[/sub-
port]][,...]}|vlan <1-4059>|vrfWORD <1–16>|
vrfidsWORD <0–255>]
Use the detail parameter to show IGMPv3–specific data.
For data related to a specific interface use the following:
• port{slot/port[/sub-port][-slot/port[/sub-port]][,...]} —
Specifies the port list.
• vlan <1-4059>— Specifies the VLAN.
Specifies the VLAN ID in the range of 1 to 4059. VLAN
IDs 1 to 4059 are configurable. The system reserves
VLAN IDs 4060 to 4094 for internal use. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID
1.
• vrf WORD<1–16>
— Specifies the VRF name.
• vrfids WORD<0–255> — Specifies the VRF ID.
tracked-members Use the tracked-members parameter to view all the tracked
members for a specific group.
vrf WORD<1–16> Specifies the VRF name.
vrfids WORD<0–512> Specifies the VRF ID.
Use the data in the following table to use the show ip igmp group group <A.B.C.D>
tracked-members command.
Variable
Value
member-subnet {default| <A.B.C.D>}] Specifies the IP address and mask of the IGMP member.
port {slot/port[/sub-port][-slot/port[/sub-port]]
[,...]}
Specifies the port list.
source-subnet <A.B.C.D/X> Specifies the source IP address and the subnet mask.
Table continues…
Viewing IGMP group information
January 2017 Troubleshooting 273
Comments on this document? [e-mail]