Troubleshooting Guide

Switch:1(config)#show ip igmp ssm
================================================================================
Igmp Ssm Global - GlobalRouter
================================================================================
DYNAMIC LEARNING SSM GROUP RANGE
--------------------------------------------------------------------------------
enable 233.252.0.0/255.0.0.0
Job aid
The following table shows the field descriptions for the show ip igmp ssm-map command.
Table 45: show ip igmp ssm-map command
Field Description
GROUP Indicates the IP multicast group address that uses the default range of 232/8.
SOURCE Indicates the IP address of the source that sends traffic to the group source.
MODE Indicates that the entry is a statically configured entry (static) or a dynamically learned entry
from IGMPv3 (dynamic).
ACTIVE Indicates the activity on the corresponding source and group. If the source is active and
traffic is flowing to the switch, this status is active; otherwise, it is nonactive.
STATUS Indicates the administrative state and whether to use the entry. If the status is enabled
(default), the entry is used. If the status is disabled, the entry is not used but is saved for
future use.
The following table shows the field descriptions for the show ip igmp ssm command.
Table 46: show ip igmp ssm command
Field
Description
DYNAMIC LEARNING Indicates whether dynamic learning is enabled at a global level.
SSM GROUP RANGE Indicates the IP address range for the SSM group.
Multicast troubleshooting
January 2017 Troubleshooting 266
Comments on this document? [e-mail]