Troubleshooting Guide

remove the existing MEP or MIP on the SPBM B-VLAN. If you want to continue configuring
MEPs manually, skip this procedure.
Procedure
1. From the navigation tree, expand the following folders: Configuration > Edit > Diagnostics.
2. Click CFM.
3. Click the Global tab.
4. Select enable next to SpbmAdminState.
5. Click Apply.
6. To verify the values assigned to MA, MD, and MEP, perform the following steps:
a. Click the MD tab.
b. Select SPBM, and then check the MA and MEP values.
CFM Global field descriptions
Use the data in the following table to configure the global MEP and MIP parameters.
Name Description
SpbmAdminState Enables or disables autogenerated CFM for B-
VLANs. The default is disable.
SpbmLevel Specifies the global SPBM CFM maintenance level
for the chassis within the range of 0 to 7. The default
is 4.
Only configure global CFM at one MD level for each
chassis for each VLAN type.
SpbmMepId Specifies the global MEP ID within the range of 1 to
8191. Select a unique ID for each switch to ensure
that the MEPs are unique across the network. The
default is 1.
CmacAdminState Enables or disables autogenerated CFM for C-
VLANs. The default is disable.
This field appears only for VSP 4000 Series.
CmacLevel Specifies the global C-MAC CFM maintenance level
for the chassis within the range of 0 to 7. The default
is 4. Only configure global CFM at one MD level for
each chassis for each VLAN type.
This field appears only for VSP 4000 Series.
CmacMepId Specifies the global MEP ID within the range of 1 to
8191. Select a unique ID for each switch to ensure
that the MEPs are unique across the network. The
default is 1.
Table continues…
CFM configuration using EDM
January 2017 Troubleshooting 185
Comments on this document? [e-mail]