Troubleshooting Guide

======================================
0 enable 4 00:15:e8:b8:a3:de
Variable definitions
Use the data in the following table for the cfm cmac command.
Variable Value
level<0-7> Specifies the global C-MAC CFM maintenance level
for the chassis within the range of 0 to 7. The default
is 4.
Only configure global CFM at one MD level for each
chassis for each VLAN type.
mepid<1-8191> Specifies the global MEP ID within the range of 1–
8191. Select a unique ID for each switch to ensure
that the MEPs are unique across the network. The
default is 1.
Note:
The MA takes its name from this value for
autogenerated CFM. For example, if you specify
500 as the MEP ID, the MA will also be 500.
enable Enables autogenerated CFM for all C-MAC VLANs.
Job aid
The following table describes the fields for the show cfm cmac command.
Parameter
Description
LEVEL Specifies the global C-VLAN CFM maintenance level
for the chassis. The default is 4.
ADMIN Specifies if CFM C-VLAN MEPs and MIPs are
globally enabled.
MEP ID Specifies the global MEP ID. The default is 1.
MAC Specifies the MAC address.
Configuring explicit mode CFM
In the explicit mode of configuring CFM, you can manually configure an MD, MA, MEP and then
associate the MEP to a B-VLAN and assign a MIP level to a B-VLAN.
Note:
If you use autogenerated CFM, these steps are unnecessary.
CFM configuration using ACLI
January 2017 Troubleshooting 159
Comments on this document? [e-mail]