Troubleshooting Guide

Example
VSP-4850GTSPWR+:1> enable
VSP-4850GTSPWR+:1# configure terminal
VSP-4850GTSPWR+:1(config)# interface gigabitethernet 1/1
VSP-4850GTSPWR+:1(config-if)# action flushAll
VSP-4850GTSPWR+:1(config-if)# exit
VSP-4850GTSPWR+:1(config)# clear ip route gigabitethernet 1/1
Variable definitions
Use the data in the following table to use the clear ip route command.
Table 32: Variable definitions
Variable Value
<1-4059> Specifies the VLAN ID in the range of 1 to 4059.
VLAN IDs 1 to 4059 are configurable. The system
reserves VLAN IDs 4060 to 4094 for internal use.
VLAN ID 1 is the default VLAN and you cannot
create or delete VLAN ID 1.
{slot/port} Specifies a port number.
Pinging an IP device
About this task
Ping a device to test the connection between the Avaya Virtual Services Platform 4000 Series and
another network device. After you ping a device, the switch sends an Internet Control Message
Protocol (ICMP) packet to the target device. If the device receives the packet, it sends a ping reply.
After the switch receives the reply, a message appears that indicates traffic can reach the specified
IP address. If the switch does not receive a reply, the message indicates the address does not
respond.
Ping and traceroute can fail for VRF routes if you use large packet sizes for the operation. Do not
use packet sizes larger than the following:
• Traceroute for VRF: 1444 bytes
Note:
Pinging a device over VRF using its IP address is successful only when the source IP address
is specified.
Pinging an IP device
January 2017 Troubleshooting 117
Comments on this document? [e-mail]