Troubleshooting Guide

Variable definitions
Use the data in the following table to use the filter acl ace action command.
Table 30: Variable definitions
Variable Value
1-2048 Specifies the ACL ID from 1–2048
1-2000 Specifies the ACE ID from 1–2000.
monitor-dst-mlt <1–512> Configures mirroring to a destination MLT group.
monitor-dst-ports {slot/port[-slot/
port ][,...]}
Configures mirroring to a destination port or ports.
{permit|deny} Configures the action mode for security ACEs. The default value is
permit.
Clearing ARP information for an interface
Before you begin
• You must log on to at least Privileged EXEC mode in ACLI.
About this task
Clear the Address Resolution Protocol (ARP) cache as part of ARP problem resolution procedures.
Procedure
Clear ARP information:
clear ip arp interface gigabitethernet {slot/port[-slot/port][,...]}
OR
clear ip arp interface vlan <1-4059>
Example
VSP-4850GTSPWR+:1> enable
VSP-4850GTSPWR+:1# clear ip arp interface gigabithethernet 1/1
Variable definitions
Use the data in the following table to use the clear ip arp interface command.
Clearing ARP information for an interface
January 2017 Troubleshooting 115
Comments on this document? [e-mail]