Performance Management on Virtual Services Platform 4000 Series Version 5.1.2

This test is similar to traceroute but also includes DSCP values at each hop in the path from
the source to the destination. The destination does not need to be an SLA Mon agent.
Limitations
SLA Mon agent communications are IPv4–based. Agent communications do not currently support
IPv6.
SLA Mon configuration using CLI
Configuring the SLA Mon agent
Configure the SLA Mon agent to communicate with an Avaya Diagnostic Server with SLA Mon
technology to perform Quality of Service (QoS) tests of the network.
Before you begin
• To use the SLA Mon agent, you must have an Avaya Diagnostic Server with SLA Mon
technology in your network.
About this task
To configure the SLA Mon agent, you must assign an IP address and enable it. Remaining agent
parameters are optional and you can operate the agent using the default values.
Note:
If you want to change SLA Mon parameters, you must first disable SLA Mon.
If you configure the SLA Mon agent address under an IP address for a VLAN or brouter, you must
remove the SLA Mon address before you can remove the IP address for the VLAN or brouter. To
remove the SLA Mon address, first use the command no slamon oper-mode enable, followed
by slamon agent ip address 0.0.0.0.
Procedure
1. Enter Application Configuration mode:
enable
configure terminal
application
2. Configure the SLA Mon agent IP address:
Limitations
January 2017 Performance Management on Avaya VSP 4000 Series 187
Comments on this document? [e-mail]