Installation Instructions

3. Grasp the transceiver between your thumb and forefinger.
4. Insert the transceiver into the proper module on the switch. Apply a light pressure to the
transceiver until it clicks and locks into position in the module.
5. Remove the dust cover from the transceiver optical bores.
Removing SFP transceivers
Remove SFP transceivers by performing this procedure.
1. Disconnect the network fiber cable from the transceiver.
2. Use the locking mechanism on the transceiver to release it. The locking mechanism varies
from model to model as illustrated below.
3. Slide the transceiver from the module slot.
4. If the transceiver does not slide easily from the module slot, use a gentle side-to-side rocking
motion while firmly pulling the transceiver from the slot.
5. Attach a dust cover over the fiber-optic bores and store the transceiver in a safe place until
you need it.
Important:
Discard transceivers in accordance with the proper laws and regulations.
Power specifications for Avaya VSP 4000 switch 4450GTX-HT-PWR+
The following table describes the regulatory AC power specifications for the Avaya Virtual Services
Platform 4000 Series 4450GTX-HT-PWR+ switch. The regulatory power specifications are based on
the maximum rated capacity of the power supplies and are not based on typical power consumption
which is lower.
Table 1: AC power specifications
4450GTX-HT-PWR+
Input Current: 16.66A/8.33A
Input Voltage (rms): 100 to 240VAC at 50 to 60 Hz
Power Consumption: • Without PoE+
- Typical: 100W
August 2014 Installation Job Aid (English) for Avaya VSP 4000 4450GTX-HT-PWR+ 7