Installation Instructions

Warning:
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables are connected to a light
source.
Caution:
Risk of high current and board burn out if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Warning:
The lithium battery is not field replaceable. It must only be removed and replaced by authorized
personnel. Contact Avaya Technical Support for assistance if the battery requires replacement.
Location restrictions
The VSP 4450GTX-HT-PWR+ must be installed in a restricted access location, such as a dedicated
equipment room, or an electrical closet.
A restricted access location is a location for equipment where both of the following apply:
• Access can only be gained by service persons or by users who have been instructed about the
reasons for the restrictions applied to the location and about any precautions that must be
taken.
• Access is through the use of a tool or lock and key, or other means of security, and is
controlled by the authority responsible for the location.
Before you begin
Ensure the area where you install and use the VSP 4000 switch meets the following environmental
requirements:
• Ambient temperature between 0° and 70° C
• Relative humidity between 0% and 95% noncondensing
• No nearby heat sources such as hot air vents or direct sunlight
• No nearby sources of severe electromagnetic noise
• No excessive dust
• Adequate power source within six feet; one 15-Amp circuit required for each power supply
• At least 2 inches (5.08 cm) on all sides of the switch unit for ventilation
• Adequate space at the front and rear of the switch for access to cables
August 2014 Installation Job Aid (English) for Avaya VSP 4000 4450GTX-HT-PWR+ 3