Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Avaya Virtual Services Platform 4000 regulatory information and safety precautions
- International regulatory statements of conformity
- National electromagnetic compliance (EMC) statements of compliance
- FCC statement (USA only)
- ICES statement (Canada only)
- CE marking statement (Europe only)
- European Union and European Free Trade Association (EFTA) notice
- VCCI statement (Japan/Nippon only)
- BSMI statement (Taiwan only)
- MIC notice (Republic of Korea only)
- National Safety Statements of Compliance
- EN 60950 statement
- NOM statement (Mexico only)
- Información NOM (unicamente para México)
- Denan statement (Japan/Nippon only)
- National Environmental Statements of Compliance
- Restriction on Hazardous Substances Directive Compliance Statement
- WEEE Directive Compliance Statement
- Chapter 2: Introduction
- Chapter 3: New in this release
- Chapter 4: Safety and equipment care information
- Chapter 5: Small form factor pluggable transceivers
- Chapter 6: Small form factor pluggable plus transceivers
- Chapter 7: SFP specifications
- SFP labels
- General SFP specifications
- 1000BASE-T (RJ-45) SFP specifications
- 1000BASE-SX (LC) DDI SFP specifications
- 1000BASE-LX (LC) DDI SFP specifications
- 1000BASE-XD DDI 1310 nm SFP specifications
- 1000BASE-XD DDI 1550 nm SFP specifications
- 1000BASE-ZX DDI SFP specifications
- 1000BASE-XD CWDM (LC) SFP specifications
- 1000BASE-ZX CWDM (LC) SFP specifications
- 1000BASE-BX10 DDI SFP specifications
- 1000BASE-EX DDI SFP specifications
- 1000BASE-BX40 bidirectional SFP specifications
- 100BASE-FX SFP specifications
- Chapter 8: SFP+ specifications
Job aid
Depending on the transceiver manufacturer, your SFP transceiver can have various types of
locking and extractor mechanisms.
The following figures shows a typical mechanisms used on SFP transceivers. Other locking
and extractor mechanisms exist, although they are not shown here. In the following figure, the
SFP still has the bore plug installed. Pull the bail to release the device.
The following figure shows the 1000BASE-SX MT-RJ SFP. Push the tab to release the
device.
The following figure shows the wrap-around latch-type extraction mechanism. To remove the
device, push the collar towards the module.
Installing an SFP
Installation — SFP and SFP+ transceivers January 2014 33