Installation Instructions

To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Warning:
Risk of equipment damage
Only trained personnel can install this product.
Procedure steps
1. Remove the SFP from its protective packaging.
2. Grasp the SFP between your thumb and forefinger.
3. Insert the device into one of the available SFP slots on the device.
Warning:
Risk of equipment damage
SFPs are keyed to prevent incorrect insertion. If the SFP resists pressure, do not
force it; turn it over, and reinsert it.
Apply a light pressure to the device until it clicks and locks into position.
1. VSP 4000 USB cover
2. Switch LEDs
3. 10/100/1000 PoE+ ports (LEDs above ports)
4. Combo port SFP slots. Supports Avaya 1G SFPs and 100Base low speed
SFPs.
5. SFP+ slots. Supports Avaya 1G SFPs and 10G SFP+s.
6. Console Port
4. Remove the dust cover from the optical bore and insert the fiber optic connector.
Small form factor pluggable transceivers
32 Installation — SFP and SFP+ transceivers January 2014
Comments? [e-mail]