Installation Instructions

Prerequisites
• a lens-grade, lint-free tissue,for example, Kimwipes.
• an optical-grade isopropyl alcohol (IPA) (98% or more purity).
• a high-quality canned compressed air with extension tube.
Compressed air must be free of dust, water, and oil, and film-like deposits that can scratch
the surface of the connector.
• You need a fiber optic microscope to inspect connectors.
Danger:
Risk of eye injury
When inspecting a connector, ensure that light sources are off. The light source used in fiber
optic cables can damage your eyes.
To avoid getting debris in your eyes, wear safety glasses when working with the canned air
duster.
To avoid eye irritation on contact, wear safety glasses when working with isopropyl
alcohol.
Procedure steps
1. Remove dust or debris by applying canned air to the cylindrical and end-face
surfaces of the connector.
2. Gently wipe the cylindrical and end-face surfaces with a tissue dampened with
optical-grade isopropyl alcohol.
3. Gently wipe the cylindrical and end-face surfaces with a dry tissue.
Important:
Do not let the IPA evaporate; wipe it dry immediately. Alcohols can leave a
residue that is difficult to remove.
4. Dry the connector surfaces by applying canned air.
5. Inspect the connector to ensure it is clean and undamaged.
To prevent contamination, do not touch the connector surfaces after cleaning. Cover
connectors with dust caps if you are not going to use them immediately.
Safety and equipment care information
22 Installation — SFP and SFP+ transceivers January 2014
Comments? [e-mail]