Installation Instructions

Label Color and Status Description
Green, Steady The SFP port and the transmit port are active.
Amber, Blink Not applicable.
Amber, Steady SFP Installed—TX Port Inactive
Off No SFP transceiver is present.
Link / Activity Green, Blink Activity exists on the port.
Green, Slow Blink Software disabled this port.
Green, Steady The link is operating normally.
Off No link exists.
Table 14: SFP+ Port LED state indicators
Label Color and Status Description
TX / RX Green, Steady SFP+ detected and link established
Green, Flashing SFP+ established and transmit/receive activity
detected.
Amber, Steady SFP detected and link established
Amber, Flashing SFP established and transmit/receive activity
detected.
Amber, Blinking TX and RX blink together slowly to indicate a disabled
port.
Off No SFP or SFP+ connection detected.
Note:
If you connect two ports explicitly set for different speeds (for example one configured as
10BaseT
and the other as 100BaseTX) the port link LED may indicate a link, but the switch
does not establish a link. Connect ports using the same set speed or use auto-negotiation
on each switch.
Installing the Avaya Virtual Services Platform 4000
44 Installation May 2013
Comments? [e-mail]