Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Avaya Virtual Services Platform 4000 regulatory information and safety precautions
- International regulatory statements of conformity
- National electromagnetic compliance (EMC) statements of compliance
- FCC statement (USA only)
- ICES statement (Canada only)
- CE marking statement (Europe only)
- European Union and European Free Trade Association (EFTA) notice
- VCCI statement (Japan/Nippon only)
- BSMI statement (Taiwan only)
- MIC notice (Republic of Korea only)
- National Safety Statements of Compliance
- EN 60950 statement
- NOM statement (Mexico only)
- Información NOM (unicamente para México)
- Denan statement (Japan/Nippon only)
- National Environmental Statements of Compliance
- Restriction on Hazardous Substances Directive Compliance Statement
- WEEE Directive Compliance Statement
- Chapter 2: Introduction
- Chapter 3: New in this release
- Chapter 4: Hardware compatibility
- Chapter 5: Installing the Avaya Virtual Services Platform 4000
- Installation fundamentals
- Electrostatic discharge
- Environmental requirements
- Package contents
- Installing the Avaya Virtual Services Platform 4000 on a table or shelf
- Installing the Avaya Virtual Services Platform 4000 in an equipment rack
- Cable requirements for the Avaya Virtual Services Platform 4000
- Installation and removal of Small Form-factor Pluggable (SFP) transceivers
- RJ-45 connector pin assignments
- Console port pin assignments
- Power specifications for the Avaya Virtual Services Platform 4000
- Avaya Virtual Services Platform power supply power specification
- Installing the Avaya Virtual Services Platform 4000 power supply
- Connect AC power
- Check Light Emitting Diode (LED) on the Avaya Virtual Services Platform 4000
- Chapter 6: Translations of safety messages
Label Color and Status Description
Off No power to secondary power supply. The switch is
not
connected to an RPS or secondary power supply.
The RPS is not supplying power, or the DC/DC module
is not supplying power..
Port LED state indicators
This section describes the port LED state indicators by color and fluctuation cues.
The following list describes the three port LEDs:
•
Activity indicates the level of activity on the link.
• Link indicates the presence of an Ethernet link.
• Speed indicates the port speed (for example, 10 Mb/s, 100 Mb/s, 1000 Mb/s).
Table 12: RJ-45 Port LED state indicators
Label Color and Status Description
Speed/PoE
+
Green, Blink The port is set to operate at 1000 Mb/s with PoE.
Green, Steady The port is set to operate at 1000 Mb/s without PoE
+.
Amber, Blink The port is set to operate at 100 Mb/s with PoE+.
Amber, Steady The port is set to operate at 100 Mb/s without PoE+.
Amber, Green Pulse The port is experiencing a PoE+ error.
Off When the Link/Activity LED is green and the Speed
LED is off, the port is set to operate at 10 Mb/s for all
models.
Link /
Activity
Green, Steady The link established but no data activity exists.
Green, Blink The link is established and data activity exists (the
blink rate indicates the level of activity).
Green, Slow Blink The software disabled the port.
Amber, Steady Port disabled.
Amber, Blink Port not used.
Table 13: SFP transceiver Port LED state indicators
Label Color and Status Description
In Use Green, Blink Not applicable.
Check Light Emitting Diode (LED) on the Avaya Virtual Services Platform 4000
Installation May 2013 43