Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Avaya Virtual Services Platform 4000 regulatory information and safety precautions
- International regulatory statements of conformity
- National electromagnetic compliance (EMC) statements of compliance
- FCC statement (USA only)
- ICES statement (Canada only)
- CE marking statement (Europe only)
- European Union and European Free Trade Association (EFTA) notice
- VCCI statement (Japan/Nippon only)
- BSMI statement (Taiwan only)
- MIC notice (Republic of Korea only)
- National Safety Statements of Compliance
- EN 60950 statement
- NOM statement (Mexico only)
- Información NOM (unicamente para México)
- Denan statement (Japan/Nippon only)
- National Environmental Statements of Compliance
- Restriction on Hazardous Substances Directive Compliance Statement
- WEEE Directive Compliance Statement
- Chapter 2: Introduction
- Chapter 3: New in this release
- Chapter 4: Hardware compatibility
- Chapter 5: Installing the Avaya Virtual Services Platform 4000
- Installation fundamentals
- Electrostatic discharge
- Environmental requirements
- Package contents
- Installing the Avaya Virtual Services Platform 4000 on a table or shelf
- Installing the Avaya Virtual Services Platform 4000 in an equipment rack
- Cable requirements for the Avaya Virtual Services Platform 4000
- Installation and removal of Small Form-factor Pluggable (SFP) transceivers
- RJ-45 connector pin assignments
- Console port pin assignments
- Power specifications for the Avaya Virtual Services Platform 4000
- Avaya Virtual Services Platform power supply power specification
- Installing the Avaya Virtual Services Platform 4000 power supply
- Connect AC power
- Check Light Emitting Diode (LED) on the Avaya Virtual Services Platform 4000
- Chapter 6: Translations of safety messages
• Screws to attach the switch to the equipment rack
3. Rubber footpads
4. AC power cord
5. Documentation
Note:
Cable trays can be provided as an option.
Installing the Avaya Virtual Services Platform 4000 on a
table or shelf
You
can install a single Avaya VSP 4000 switch on any flat surface. The surface must support
the combined weight of the switch and attached cables (from 15 and 20 pounds [7 to 9
kilograms]).
To install an Avaya VSP 4000 on a table or shelf, perform this procedure.
Caution:
Do not place an Avaya Ethernet Power Supply Unit or Avaya Ethernet Redundant Power
Supply on top of an Avaya VSP 4000. The switch housing of an Avaya VSP 4000 cannot
support the weight of these units. For a translation of this statement, see Translations of
safety messages on page
45.
1. Attach the included rubber footpads on the bottom of the switch at the locations.
Installing the Avaya Virtual Services Platform 4000
28 Installation May 2013
Comments? infodev@avaya.com