Installation Instructions

1000BASE-ZX DDI CWDM 70 km SFP specifications
The following table describes specifications for CWDM SFP transceivers numbered AA1419061-E6
to AA1419068-E6*.
Warning:
Risk of equipment damage
To prevent damage to the optical receiver, ensure that at least 8 dB of attenuation is present
between the transmit and receive ports.
* This transceiver has reached end of sale (EOS). For more information about EOS transceivers and
recommended replacements for your product, or to determine existing availability for EOS
transceivers, see Locating end of sale notices on page 10.
Important:
AA1419065–E6 remains available to purchase.
Table 15: 1000BASE-ZX CWDM SFP (70 km) specifications
Parameter Specifications
Maximum electrical power consumption 1.0 W
Connectors Duplex LC
Cabling SMF, 9 µm
Data rate 1.0 Gbps
Line rate (8B/10B code) 1.25 Gbps
Link optical power budget 24 dB
Maximum dispersion power penalty 2 dB at 70 km
Transmitter characteristics
Launch power 0 to 5.0 dBm
Receiver characteristics
Receiver sensitivity –24 dBm
Maximum receiver power –3.0 dBm
1000BASE-BX bidirectional SFP transceivers
The 1000BASE-BX bidirectional DDI SFP transceivers provides gigabit Ethernet connectivity over a
single fiber.
In the following figure, the transmit (Tx) and receive (Rx) paths share the same fiber by using two
different wavelengths. One model transmits at 1310 nm and receives at 1490 nm, while the mating
model transmits at 1490 nm and receives at 1310 nm. You can only connect a mating pair.
SFP specifications
December 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 39
Comments on this document? [e-mail]