Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Preface
- Chapter 2: New in this document
- Chapter 3: Safety and equipment care information
- Chapter 4: Supported transceiver, BOCs and DACs
- Chapter 5: Optical routing design
- Chapter 6: SFP
- Chapter 7: SFP+
- SFP+ transceivers
- SFP+ specifications
- SFP+ labels
- General SFP+ specifications
- Supported SFP+ transceivers
- 10GBASE-T SFP+ transceiver
- 10GBASE-LR/LW SFP+ specifications
- 10GBASE-LR/LW SFP+ high temperature (-5 °C to +85 °C) specifications
- 10GBASE-ER/EW SFP+ specifications
- 10GBASE-SR/SW SFP+ specifications
- 10GBASE-SR/SW SFP+ high temperature (0 °C to +85 °C) specifications
- 10GBASE-ZR/ZW SFP+ specifications
- 10GBASE-LRM SFP+ specifications
- 10GBASE-BX SFP+ specifications
- 10GBASE-CX specifications
- Chapter 8: QSFP+
- Chapter 9: QSFP28
- Chapter 10: End of sale transceivers and cables
- Chapter 11: Translations of safety messages
- Class A electromagnetic interference warning statement
- Electrostatic discharge warning statement
- Laser eye safety danger statement
- Laser eye safety connector inspection danger statement
- Connector cleaning safety danger statement
- Optical fiber damage warning statement
- Optical fiber connector damage warning statement
- SFP damage warning statement
- Glossary
media A substance that transmits data between ports; usually fiber optic cables or
category 5 unshielded twisted pair (UTP) copper wires.
metropolitan area
network (MAN)
A broadband network that covers an area larger than a Local Area Network.
multimode fiber
(MMF)
A fiber with a core diameter larger than the wavelength of light transmitted
that you can use to propagate many modes of light. Commonly used with
LED sources for low speed and short distance lengths. Typical core sizes
(measured in microns) are 50/125, 62.5/125 and 100/140.
multiplexing
Carriage of multiple channels over a single transmission medium; a process
where a dedicated circuit is shared by multiple users. Typically, data
streams intersperse on a bit or byte basis (time division), or separate by
different carrier frequencies (frequency division).
nanometer (nm)
One billionth of a meter (10
-9
meter). A unit of measure commonly used to
express the wavelengths of light.
QSFP+ A hot pluggable, quad small form-factor pluggable plus (QSFP+)
transceiver, which is used in 40 Gbps and 4x10 Gbps Ethernet applications.
4x10 Gbps requires channelization support.
QSFP28 A hot pluggable, quad small form-factor pluggable 28 (QSFP28)
transceiver, which is used in 100 Gbps and 4x25 Gbps Ethernet
applications. 4x25 Gbps requires channelization support. It is similar in
physical appearance to QSFP+ transceivers.
SFP
A hot pluggable, small form-factor pluggable (SFP) transceiver, which is
used in Ethernet applications up to 1 Gbps.
SFP+ A hot pluggable, small form-factor pluggable plus (SFP+) transceiver, which
is used in Ethernet applications up to 10 Gbps. It is similar in physical
appearance to SFP transceivers.
single-mode fiber
(SMF)
One of the various light waves transmitted in an optical fiber. Each optical
signal generates many modes, but in single-mode fiber only one mode is
transmitted. Transmission occurs through a small diameter core
(approximately 10 micrometers), with a cladding that is 10 times the core
diameter. These fibers have a potential bandwidth of 50 to 100 gigahertz
(GHz) per kilometer.
unshielded twisted
pair (UTP)
A cable with one or more pairs of twisted insulated copper conductors
bound in a single plastic sheath.
media
May 2018 Installing Transceivers and Optical Components on VOSS 85










