Installation Instructions

40GBASE-SR4 QSFP+ specifications
The 40GBASE-SR4 4x10GBASE-SR transceiver provides a high-speed link at an aggregate
signaling rate.
Important:
Not all Extreme Networks networking products support the 4x10GBASE-SR mode of operation.
The 40GBASE-SR4 transceiver supports the MPO connector. Typically, the MPO connector has two
alignment pins, which keeps the connector and the fibers aligned to the mating cable.
For more information about the 40GBASE-SR4 4x10GBASE-SR QSFP+ transceiver, including test
and measurement information, see the IEEE 802.3-2012 standard.
The following table lists the specifications for the 40GBASE-SR4 4x10GBASE-SR QSFP+
transceiver. The part number of this QSFP+ transceiver is AA1404005-E6.
Table 21: 40GBASE-SR4 4x10GBASE-SR QSFP+ transceiver specifications
Parameter Specification
Line rate 10.3125 Gbps
Center wavelength range 840 to 860 nanometers
Distance Up to:
• 328 feet (100 meters) – with OM3 fiber
cable.
• 492 feet (150 meters) – with OM4 fiber
cable.
Transmitter characteristics
Signaling rate, each lane 10.3125 Gbps
RMS spectral width 0.65 nanometers maximum
Average launch power, each lane Min Max Units
–8.0 –1.0 dBm
Optical modulation amplitude (OMA),
each lane
Min Max Units
–5.6 3 dBm
Maximum transmitter and dispersion penalty (TDP), each lane 3.9 dB
Minimum launch power in OMA minus TDP, each lane –7.8 dBm
Minimum extinction ratio 3 dB
Maximum optical return loss tolerance 12 dB
Receiver characteristics
Signaling rate, each lane 10.3125 Gbps
Average receive power, each lane Min Max Units
–9.5 2.4 dBm
Receive power in OMA, each lane Min Max Units
QSFP+
May 2018 Installing Transceivers and Optical Components on VOSS 56