Installation Instructions

due to the PHYless design, this transceiver is not supported. For the VSP 7200 Series, use the
10GBASE-ZR CWDM DDI SFP+ transceiver with part number AA1403165-E6.
Warning:
Risk of BER increase
For proper SFP+ transceiver operation, ensure that at least 11 dB of attenuation is present
between the transmit and receive ports.
The reach for this SFP+ transceiver is up to 70 km* at a wavelength of 1550 nm.
Table 16: 10GBASE-ZR/ZW SFP+ specifications
Parameter Specifications
Line rate (nominal) 10GBASE-ZR 10.3125 Gbps ±100 ppm (10 GbE)
Distance Up to 70 km *
Link optical power budget 24 dB
Dispersion power penalty 3.0 dB at 70 km (G.652 fiber)
Minimum attenuation between transmit and receive
ports
11 dB
Transmitter characteristics
Center wavelength range 1530 to 1565 nm, nominal 1550 nm
Average launch power 0 to 4.0 dBm
Optical modulation amplitude (minimum) –1.7 dBm
Extinction ratio (ER) (minimum) 8.2 dB
Maximum transmitter reflectance –12 dB
Receiver characteristics
Wavelength range 1280 to 1575 nm. Sensitivity specified for 1530 to
1565 nm.
Maximum receiver sensitivity (average power) –24 dBm
Maximum receiver (average) power, BER 10
-12
–7.0 dBm
Receiver damage threshold (average power) +5.0 dBm
Receiver reflectance (maximum) –27 dB
* Achievable link distance is primarily dependent on cable plant insertion loss. 70 km is not possible
in some situations.
10GBASE-LRM SFP+ specifications
The 10GBASE-LRM SFP+ transceiver provides 10 GbE service at a wavelength of 1310 nm. This
SFP+ transceiver supports a reach of up to 220 m on 62.5 μm multimode fiber (MMF), as specified
in IEEE 802.3-2015 CL68. This SFP+ transceiver can also be used with standard single mode fiber
(SMF) to attain a reach of up to 300 m.
SFP+
May 2018 Installing Transceivers and Optical Components on VOSS 46