Installation Instructions
Table Of Contents
- Notices
- Safety messages
- Before you begin
- Installing the VSP 4450GTX-HT-PWR+
- Installing the Virtual Services Platform 4000 on a table or shelf
- Installing the Virtual Services Platform 4000 in an equipment rack
- Installing SFP transceivers
- Removing SFP transceivers
- Power specifications for VSP 4450GTX-HT-PWR+
- Virtual Services Platform power supply power specification
- Installing the VSP 4450GTX-HT-PWR+ power supply
- Connecting to AC power
3. Insert and tighten the rack-mount screws.
Installing SFP transceivers
Install SFP transceivers by performing this procedure.
1. Remove the transceiver from the protective packaging.
2. Verify that the transceiver is the correct model for the network configuration.
3. Grasp the transceiver between your thumb and forefinger.
4. Insert the transceiver into the proper module on the switch. Apply a light pressure to the
transceiver until it clicks and locks into position in the module.
5. Remove the dust cover from the transceiver optical bores.
Removing SFP transceivers
Remove SFP transceivers by performing this procedure.
1. Disconnect the network fiber cable from the transceiver.
2. Use the locking mechanism on the transceiver to release it. The locking mechanism varies
from model to model as illustrated below.
November 2017 Installation Job Aid for VSP 4450GTX-HT-PWR+ 6