Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Preface
- Chapter 2: New in this document
- Chapter 3: Hardware models
- Chapter 4: Preinstallation checklist
- Chapter 5: Installing the VSP 4450GTX-HT-PWR+
- Installation checklist
- Installation fundamentals
- Electrostatic discharge
- Technical specifications
- Environmental requirements
- Airflow direction
- Package contents
- Installing the Virtual Services Platform 4000 on a table or shelf
- Installing the Virtual Services Platform 4000 in an equipment rack
- Cable requirements for the Virtual Services Platform 4000
- Installation and removal of Small Form Factor Pluggable (SFP) transceivers
- RJ45 connector pin assignments
- Console port pin assignments
- Installing the Virtual Services Platform 4000 power supply
- Connect AC power
- LED state definitions
- Viewing hardware information
- Chapter 6: Translations of safety messages
Chapter 5: Installing the VSP 4450GTX-HT-
PWR+
Installation checklist
Use this checklist to install the VSP 4450GTX-HT-PWR+.
No. Task Description
1. Install the VSP 4450GTX-HT-PWR+. You can install the switch in two ways:
• Installing the Virtual Services Platform 4000
on a table or shelf on page 21
• Installing the Virtual Services Platform 4000
in an equipment rack on page 22
2. Install the primary or redundant
power supply.
Important:
A combination of AC-input and
DC-input power supplies in the
same chassis is not supported.
For the procedure to install power supply, see
Installing the VSP 4000 Series PWR power
supply on page 27.
3. Check the LEDs to verify the
installation.
For a description of the LEDs, see Check Light
Emitting Diode (LED) on VSP 4000 on
page 32.
Installation fundamentals
The following section describes the installation fundamentals for the VSP 4450GTX-HT-PWR+
model.
VSP 4450GTX-HT-PWR+ model
The VSP 4450GTX-HT-PWR+ model consists of:
1. 48 10/100/1000 Mbps RJ45 ports with PoE+
Table continues…
August 2018 Installing the Virtual Services Platform 4450GTX-HT-PWR+ 16