Design Reference

Note:
The 300W and 1000 W AC power supplies use the IEC 60320 C16 AC power cord connector.
Use the order codes to order a replacement for the primary PSU or to order a redundant PSU for
your VSP 4000 system.
Table 1: Power supply order codes
VSP 4000 PSU Usage Part number
(order code)
300 W AC power
supply
For use in the ERS 4626GTS, VSP 4850GTS and
WL8180, WL8180-16L wireless controllers.
AL1905?08-E5*
1000 W AC POE+
power supply
For use in VSP 4000 series PWR+ platforms including
VSP 4450GSX–PWR+, and VSP 4850GTS-PWR+.
AL1905?21–E6*
300 W DC power
supply
For use in the VSP 4850GTS-DC, VSP 4450GSX-DC,
ERS5698TFD, 5650TD, and 5632FD.
DC connector included.
AL1905005-E5
1000 W AC POE+
power supply
For use in the VSP 4000 4450GTX-HT-PWR+ model. EC4005?03-E6*
*Note: You must replace the seventh character (?) of the switch order number with the proper letter to
indicate desired product nationalization. See the following for details:
A: No power cord included.
B: Includes European “Schuko” power cord common in Austria, Belgium, Finland, France, Germany, The
Netherlands, Norway, and Sweden.
C: Includes power cord commonly used in the United Kingdom and Ireland.
D: Includes power cord commonly used in Japan.
E: Includes North American power cord.
F: Includes Australian power cord.
Device cooling
VSP 4000 — device cooling
The VSP 4000 platform has an in-built cooling module that is not removable. Each cooling module
includes four fans providing cooling from front to back. There are three 12-volt fans to maintain
optimal operating temperature inside the box. The fans are also speed controlled, based on the
temperature in the box, in order to minimize fan noise. Temperature sensors allow the fan speed
controller to properly support the entire unit.
Caution:
Risk of electromagnetic interference:
Platform considerations
June 2015 Network Design Reference for Avaya VSP 4000 Series 19
Comments on this document? [e-mail]