Installation Instructions

Table 2: General SFP specifications
Parameter Description
Dimensions (H x W x D) 8.5 x 13.4 x 56.4 millimeters (0.33 x 0.53 x 2.22
inches), unless otherwise stated.
Operating temperature –5 to 85 ºC for RoHS -E6 models
Storage temperature –40 to 85 ºC
Maximum supply current 300 mA, unless otherwise stated
Maximum power consumption 1.0 W, unless otherwise stated
Supported SFP transceivers
The following section provides specifications for the supported SFP transceivers.
1000BASE-T SFP specifications
The 1000BASE-T SFP provides gigabit Ethernet connectivity using a single eight-pin RJ-45
connector. The 1000BASE-T SFP only operates at 1 gigabits per second (Gbps) and does not
support 100BASE-T SFP or 10BASE-T interfaces. The part number for this model is AA1419043-
E6.
Important:
You must disable autonegotiation before you use the 1000BASE-T SFP because the default
setting on most modules is autonegotiation enabled.
The maximum current requirement of the SFP is 375 milliamperes (mA) at 5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 3: IEEE 802.3z 1000BASE-T SFP specifications
Parameter Specifications
Standards IEEE 802.3z, IEEE 802.3ab
Connectors RJ-45
Cabling CAT5E or better UTP
Distance Up to 100 m
1000BASE-SX DDI SFP specifications
The 1000BASE-SX DDI SFP transceiver has a reach of up to 550 m using 50 µm MMF, and of 275
m using 62.5 µm MMF. This SFP transceiver operates at 850 nm. The part number is AA1419048-
E6.
The following table describes standards, connectors, cabling, and distance for the 1000BASE-SX
DDI SFP transceivers.
SFP
24 Installing Transceivers and Optical components on Avaya VSP 4000 February 2015
Comments? [e-mail]