Installation Instructions

Hardware Description Part number
1000BASE-ZX CWDM (LC) 1470 nm to 1610 nm, up to 70 km AA1419061-E6 to
AA1419068-E6
1000BASE-BX10 DDI SFP Bidirectional 1310 nm and 1490 nm, single
fiber LC, up to 10 km
AA1419069-E6,
AA1419070-E6 paired
device
1000BASE-EX DDI SFP 1550 nm, up to 120 km AA1419071-E6
1000BASE-BX40 Bidirectional 1310 nm and 1490 nm, single
fiber LC, up to 40 km
AA1419076–E6,
AA1419077–E6 paired
device
100BASE-FX SFP 1310 nm, LC connector AA1419074-E6
Important:
Avaya recommends the use of Avaya branded SFP transceivers as they have been through
extensive qualification and testing. Avaya will not be responsible for issues related to non-Avaya
branded SFP transceivers.
For more information about SFP specifications, see SFP specifications on page 23.
Installing an SFP
Install an SFP to provide an interface between the device and the network cable.
Before you begin
• Verify that the SFP is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Danger:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables connect to a light
source.
Electrostatic alert:
ESD can damage electronic circuits. Do not touch electronic hardware unless you wear a
grounding wrist strap or other static-dissipating device.
Warning:
Risk of equipment damage
Only trained personnel can install this product.
About this task
Installing an SFP takes approximately 3 minutes.
SFP
20 Installing Transceivers and Optical components on Avaya VSP 4000 February 2015
Comments? [e-mail]