Installation Instructions

10GBASE-ER CWDM DDI SFP+ specifications
The following table lists the part numbers of the 10GBASE-ER CWDM DDI SFP+ with
corresponding wavelengths.
Table 30: Part number and center wavelength assignment
Part number Center
wavelength
assignment
Reach Insertion loss
Tx to Rx
AA1403153-E6 1471 nm up to 40 km 5 dB
AA1403154-E6 1491 nm up to 40 km 5 dB
AA1403155-E6 1511 nm up to 40 km 5 dB
AA1403156-E6 1531 nm up to 40 km 5 dB
AA1403157-E6 1551 nm up to 40 km 5 dB
AA1403158-E6 1571 nm up to 40 km 5 dB
AA1403159-E6 1591 nm up to 40 km 5 dB
AA1403160-E6 1611 nm up to 40 km 5 dB
The following table lists the transmitter and receiver specifications for the 10GBASE-ER CWDM DDI
SFP+.
Table 31: 10GBASE-ER CWDM DDI SFP+ specifications
Parameter Specifications
Transmitter characteristics:
Optical Data Rate (nominal) 9.95 Gbps to 10.313 Gbps
Center wavelength Nominal –6.5 nm to nominal +6.5 nm
Spectral width (RMS at –20 dB) 1 nm
Average launched power –0.2 dBm to 4 dBm
Extinction ratio (minimum) 8.2 dB
Tx power, OMA (minimum) +1.5 dBm
Tx power, OMA-TDP (minimum) –0.2 dBm
TDP at 800 ps dispersion (maximum) 2.8 dB
Receiver characteristics:
Wavelength (requirement) 1450 nm to 1620 nm
Receiver sensitivity (unstressed), OMA –14.1 dBm, P_OMA
IEEE 10GBASE-ER Stressed Rx Sensitivity –11.3 dBm, P_OMA
Receiver overload –1 dBm, P_avg
Receiver reflectance –26 dB
Receiver damage threshold +4 dBm
SFP+
April 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 60
Comments on this document? [e-mail]