Installation Instructions

Table 28: 10GBASE-ZR/ZW SFP+ specifications
Parameter Specifications
Line rate (nominal) 10GBASE-ZR 10.3125 Gbps ±100 ppm (10 GbE)
Distance Up to 70 km *
Link optical power budget 24 dB
Dispersion power penalty 3.0 dB at 70 km (G.652 fiber)
Minimum attenuation between transmit and receive
ports
11 dB
Transmitter characteristics
Center wavelength range 1530 to 1565 nm, nominal 1550 nm
Average launch power 0 to 4.0 dBm
Optical modulation amplitude (minimum) –1.7 dBm
Extinction ratio (ER) (minimum) 8.2 dB
Maximum transmitter reflectance –12 dB
Receiver characteristics
Wavelength range 1280 to 1575 nm. Sensitivity specified for 1530 to
1565 nm.
Maximum receiver sensitivity (average power) –24 dBm
Maximum receiver (average) power, BER 10
-12
–7.0 dBm
Receiver damage threshold (average power) +5.0 dBm
Receiver reflectance (maximum) –27 dB
* Achievable link distance is primarily dependent on cable plant insertion loss. 70 km is not possible
in some situations.
10GBASE-CX specifications
The 10GBASE-CX is a 2-pair twinaxial copper cable that plugs into the SFP+ socket and connects
two 10-gigabit ports. The reach for this cable is up to 15 m with a bit error rate (BER) better than
10
-12
.
The 10GBASE-CX is a lower cost alternative to the optical SFP+ devices.
For more information about the 10GBASE-CX, including test and measurement information and
more specifications, see the IEEE 802.3–2012 standard. The following table identifies the part
numbers for specific cable lengths.
Table 29: 10GBASE-CX cables
Cable length
Part number
3 meter AA1403019-E6
5 meter AA1403020-E6
10 meter AA1403018-E6
SFP+ specifications
April 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 59
Comments on this document? [e-mail]