Installation Instructions

Parameter Specifications
Using 50 µm MMF optic cable:
• 400 MHz-km fiber: 2 to 66 m
• 500 MHz-km fiber: 2 to 82 m
• 2000 MHz-km fiber (OM3): 2 to 300 m
• 4700 MHz-km fiber (OM4): 2 to 400 m
Link optical power budget 7.3 dB
Maximum transmitter and dispersion penalty 3.9 dB at 300 m
Operating case temperature range 0 °C to +85 °C
Transmitter characteristics
Root-mean-square spectral width 0.05 to 0.40 nm
Launch power –7.3 to –1.0 dBm
Minimum extinction ratio 3.0 dB
Maximum optical return loss tolerance –12 dB
Receiver characteristics
Average receive power for BER 10
-12
–9.9 to –1.0 dBm
Receiver damage threshold 0dBm
Maximum receiver sensitivity in OMA –11.1 dBm
Maximum receiver reflectance –12 dB
Stressed receiver sensitivity in OMA –7.5 dBm
10GBASE-ZR/ZW SFP+ specifications
The following table lists the transmit and receive specifications for the 10GBASE-ZR/ZW SFP+
transceiver. The part number of this SFP+ transceiver is AA1403016-E6.
Note:
VSP 7254XSQ has a PHYless design which is typical for Data Center Top of Rack switches.
The benefits of a PHYless design are lower power consumption and lower latency. However,
due to the PHYless design, this transceiver is not supported. For the VSP 7200 Series, use the
10GBASE-ZR CWDM DDI SFP+ transceiver with part number AA1403165-E6.
Warning:
Risk of BER increase
For proper SFP+ transceiver operation, ensure that at least 11 dB of attenuation is present
between the transmit and receive ports.
The reach for this SFP+ transceiver is up to 70 km* at a wavelength of 1550 nm.
SFP+
April 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 58
Comments on this document? [e-mail]