Installation Instructions

Autonegotiation
Use Autonegotiation to allow the device to automatically negotiate the best common data rate and
duplex mode to use between two Autonegotiation-capable Ethernet devices.
1000BASE-SX (LC) SFP specifications
The 1000BASE-SX SFP transceiver provides 1000BASE-SX gigabit Ethernet connectivity at 850 nm
using multimode optical fiber. This SFP supports only full-duplex operation. The part number is
AA1419013-E5.
The following table describes standards, connectors, cabling, and distance for the 1000BASE-SX
SFP transceivers.
Table 3: IEEE 802.3z 1000BASE-SX (LC) SFP specifications
Parameter Specifications
Connectors Duplex LC
Cabling • 62.5 µm MMF optic cable
• 50 µm MMF optic cable
Distance • up to 275 m using 62.5 µm MMF optic cable
• up to 550 m using 50 µm MMF optic cable
Wavelength 850 nanometers (nm)
Link optical power budget 7.0 deciBels (dB)
Transmitter characteristics
Launch power –10 to –4.0 dBm
Receiver characteristics
Receiver sensitivity –17 dBm
Maximum input power 0 dBm
1000BASE-SX (MT-RJ) SFP specifications
The 1000BASE-SX (MT-RJ) type SFP provides gigabit Ethernet connectivity using MT-RJ
multimode fiber connectors. The part number is AA1419014-E5*.
* This transceiver has reached end of sale (EOS). For more information about EOS transceivers and
recommended replacements for your product, or to determine existing availability for EOS
transceivers, see Locating end of sale notices on page 11.
The following table describes standards, connectors, cabling, and distance for the 1000BASE-SX
(MT-RJ) type SFP transceiver.
SFP
April 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 32
Comments on this document? [e-mail]