Design Reference
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Network design fundamentals
- Chapter 4: Hardware fundamentals and guidelines
- Chapter 5: Optical routing design
- Chapter 6: Platform redundancy
- Chapter 7: Link redundancy
- Chapter 8: Layer 2 loop prevention
- Chapter 9: Spanning tree
- Chapter 10: Layer 3 network design
- Chapter 11: SPBM design guidelines
- Chapter 12: IP multicast network design
- Multicast and VRF-Lite
- Multicast and MultiLink Trunking considerations
- Multicast scalability design rules
- IP multicast address range restrictions
- Multicast MAC address mapping considerations
- Dynamic multicast configuration changes
- IGMPv3 backward compatibility
- IGMP Layer 2 Querier
- TTL in IP multicast packets
- Multicast MAC filtering
- Guidelines for multicast access policies
- Multicast for multimedia
- Chapter 13: System and network stability and security
- Chapter 14: QoS design guidelines
- Chapter 15: Layer 1, 2, and 3 design examples
- Chapter 16: Software scaling capabilities
- Chapter 17: Supported standards, RFCs, and MIBs
- Glossary
Figure 47: Optimized routing after moving VMs
Related Links
SPBM design guidelines on page 73
Solution-specific reference architectures
The following sections describe solution-specific reference architectures, like for example for Video
Surveillance or Data Center implementation, using the VSP 4000.
Multi-tenant — fabric connect
This fabric connect-based solution leverages the fabric capabilities of the VSP platforms: a VSP
7000 core and a VSP 4000 edge. This solution provides the ability to run up to 24 VRFs for each
wiring closet and is well suited for multi-tenant applications. The zero-touch core is enabled by the
fabric connect endpoint provisioning capabilities.
If this solution must support IPv6, then a central router-pair routes all IPv6 traffic. The IPv6 traffic is
tunneled from each wiring closet to the IPv6 routers by extending Layer 2 VSNs to the q-tagged
router interfaces.
Note:
IPv6 is not supported in the current release of VSP 4000.
SPBM design guidelines
96 Network Design Reference for Avaya VSP 4000 Series January 2015
Comments? infodev@avaya.com