Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Avaya Virtual Services Platform 4000 regulatory information and safety precautions
- International regulatory statements of conformity
- National electromagnetic compliance (EMC) statements of compliance
- FCC statement (USA only)
- ICES statement (Canada only)
- CE marking statement (Europe only)
- European Union and European Free Trade Association (EFTA) notice
- VCCI statement (Japan/Nippon only)
- BSMI statement (Taiwan only)
- MIC notice (Republic of Korea only)
- National Safety Statements of Compliance
- EN 60950 statement
- NOM statement (Mexico only)
- Información NOM (unicamente para México)
- Denan statement (Japan/Nippon only)
- National Environmental Statements of Compliance
- Restriction on Hazardous Substances Directive Compliance Statement
- WEEE Directive Compliance Statement
- Notices
- Chapter 2: Introduction
- Chapter 3: New in this release
- Chapter 4: Hardware compatibility
- Chapter 5: Installing the Avaya Virtual Services Platform 4000
- Installation fundamentals
- Electrostatic discharge
- Environmental requirements
- Package contents
- Installing the Avaya Virtual Services Platform 4000 on a table or shelf
- Installing the Avaya Virtual Services Platform 4000 in an equipment rack
- Cable requirements for the Avaya Virtual Services Platform 4000
- Installation and removal of Small Form-factor Pluggable (SFP) transceivers
- RJ-45 connector pin assignments
- Console port pin assignments
- Power specifications for the Avaya Virtual Services Platform 4000
- Avaya Virtual Services Platform power supply power specification
- Installing the Avaya Virtual Services Platform 4000 power supply
- Connect AC power
- Check Light Emitting Diode (LED) on the Avaya Virtual Services Platform 4000
- Chapter 6: Translations of safety messages
Chapter 5: Installing the Avaya Virtual
Services Platform 4000
This section provides the information and procedures to install the Avaya Virtual Services Platform
4000.
Installation fundamentals
The VSP 4000 consists of:
• 48 10/100/1000 Base TX ports
- RJ-45 for the VSP 4850GTS and VSP 4850GTS DC models
- 802.3at PoE+ for the VSP 4850GTS-PWR+ model
• two combo SFP ports
- These ports support copper and fiber on the same switch port. Only one medium
type can be active at any time.
- There is an RJ-45 connector and an SFP slot for each combo port. A cable can be
inserted into either or both medium types.
- Fiber connections take precedence over copper.
- Configuration for the port is applicable to both medium types. For example, auto-
negotiation configuration applies to both the copper and fiber ports.
• two SFP + ports
Figure 1: VSP 4850GTS
Installation February 2014 25