Design Reference

To minimize network outages, you can also use VLACP to switch traffic around entire network
devices before Layer 3 protocols detect a network failure.
VLACP is an extension of the Link Aggregation Control Protocol (LACP) but LACP and VLACP are
independent features.
VLACP does not perform link aggregation; it detects end-to-end link failures.
VLACP periodically checks the end-to-end condition of a point-to-point connection and it uses the
hello mechanism of LACP to periodically send hello packets to ensure end-to-end communication.
If VLACP does not receive hello packets it transitions to a failure state, which indicates a service
provider failure, and the port is disabled. The system sends VLACP trap messages to the
management stations if the VLACP state changes. If the failure is local, the system generates only
port linkdown or port linkup traps.
VLACP works for port-to-port communications only where a guarantee exists for a logical port-to-
port match through the service provider.
VLACP does not work for port-to-multiport communications where no guarantee exists for a point-to-
point match through the service provider.
Example:
When the enterprise networks connect the aggregated Ethernet trunk groups through a service
provider network connection, far-end failures cannot be signaled with Ethernet-based functions that
operate end-to-end through the service provider network. The multilink trunk (between enterprise
switches S1 and S2) extends through the service provider network.
The following figure shows an MLT that operates with VLACP. VLACP can operate end-to-end, but
you can also use it in a point-to-point link.
Figure 7: Problem description (1 of 2)
In the following figure, if the L2 link on S1 (S1/L2) fails, the link-down failure is not propagated over
the service provider network to S2 and S2 continues to send traffic over the failed S2/L2 link.
Link redundancy
40 Network Design Reference for Avaya VSP 4000 Series December 2014
Comments? [e-mail]