Design Reference

ManualsBrandsExtreme Networks ManualsComputers & AccessoriesFabric-enabled multi-service edge switches

131

132

133

134

135

136

137

138

139

140

Table Of Contents

Contents
Chapter 1: Introduction
- Purpose
- Related resources
- Support
Chapter 2: New in Release 4.0.50
- Features
- Other changes
Chapter 3: New in Release 4.0.40
- Features
- Other changes
Chapter 4: New in Release 4.0
- Features
- Other changes
Chapter 5: Network design fundamentals
Chapter 6: Hardware fundamentals and guidelines
- Supported hardware
- Platform considerations
- Hardware compatibility
- Supported optical devices
- Dispersion considerations for long reach
- 10/100BASE-X and 1000BASE-TX reach
- 10/100/1000BASE-TX Auto-Negotiation recommendations
- Auto MDIX
- CANA
Chapter 7: Optical routing design
- Optical routing system components
Chapter 8: Platform redundancy
- Power redundancy
- Input/output port redundancy
- Configuration redundancy
- Link redundancy
Chapter 9: Link redundancy
- Physical layer redundancy
- MultiLink Trunking
- 802.3ad-based link aggregation
Chapter 10: Layer 2 loop prevention
- Loop prevention and detection
- SLPP example scenarios
Chapter 11: Spanning tree
- Spanning tree and protection against isolated VLANs
- MSTP and RSTP considerations
Chapter 12: Layer 3 network design
- VRF Lite
- Virtual Router Redundancy Protocol
- Open Shortest Path First
- Border Gateway Protocol
- IP routed interface scaling
Chapter 13: SPBM design guidelines
- 802.1aq standard
- VLANs without member ports
- Provisioning
- Implementation options
- Reference architectures
- Solution-specific reference architectures
- Best practices
- SPBM restrictions and limitations
- IP multicast over SPBM restrictions
Chapter 14: IP multicast network design
- Multicast and VRF-Lite
- Multicast and MultiLink Trunking considerations
- Multicast scalability design rules
- IP multicast address range restrictions
- Multicast MAC address mapping considerations
- Dynamic multicast configuration changes
- IGMPv3 backward compatibility
- IGMP Layer 2 Querier
- TTL in IP multicast packets
- Multicast MAC filtering
- Guidelines for multicast access policies
- Multicast for multimedia
Chapter 15: System and network stability and security
- DoS protection mechanisms
- Damage prevention
- Data plane security
- Control plane security
- Additional information
Chapter 16: QoS design guidelines
- QoS mechanisms
- QoS interface considerations
- Network congestion and QoS design
- QoS examples and recommendations
Chapter 17: Layer 1, 2, and 3 design examples
- Layer 1 example
- Layer 2 example
- Layer 3 example
Chapter 18: Software scaling capabilities
Chapter 19: Supported standards, RFCs, and MIBs
- Supported IEEE standards
- Supported RFCs
- Quality of service
- Network management
- MIBs
- Standard MIBs
- Proprietary MIBs
Glossary

Figure 65: Layer 3 design example

Layer 1, 2, and 3 design examples

138 Network Design Reference for Avaya VSP 4000 Series December 2014

Comments? infodev@avaya.com