Installation Guide
Table Of Contents
- V2110 Virtual Appliance, MS Hyper-V Platform
- Notices
- Firmware License Agreement
- Contents
- About this Guide
- Virtual Appliance Deployment
- V2110 MS Hyper-V Platform Configuration
- Configuring Virtual Switches for the Virtual Appliance
Virtual Appliance Deployment
V2110 Virtual Appliance Installation Guide
18
5 Under Hardware, select from one of the following adapters (MgmtAdapter,
PhysAdapter1, and PhysAdapter2).
MgmtAdapter is the network the V2110's management port is expecting to connect to.
That network should be mapped to a virtual switch that will be used for management
traffic.
PhysAdapter1 is the network that the V2110's esa0 (data plane) port expects to use.
That network should be mapped to a virtual switch on the host that will carry traffic
between the V2110 and the APs.
PhysAdapter2 is the network that the V2110's esa1 (data plane) port expects to use.
That network should be mapped to a virtual switch on the ESX/ESXi host that will carry
traffic between the V2110 and the APs.
NOTE
Extreme Networks recommends not using the bandwidth management feature
since the controller performs CoS enforcement on all traffic that egresses the
controller.