Installation Guide
Table Of Contents
- V2110 Virtual Appliance, MS Hyper-V Platform
- Notices
- Firmware License Agreement
- Contents
- About this Guide
- Virtual Appliance Deployment
- V2110 MS Hyper-V Platform Configuration
- Configuring Virtual Switches for the Virtual Appliance
Virtual Appliance Deployment
V2110 Virtual Appliance Installation Guide
7
Setup Scripts to Recover VLAN Trunk Configuration on the
Appliance Reboot/Reset
The following script must be setup to be run to use tagged (VLAN) traffic on the controller
data port interface.
1 Transfer the following files to the host under directory:
C:\Users\Public\Documents\Hyper-V\SCRIPTS\
Scheduled_Task-Run_When_VM_Reboots.ps1
Commands_Executed_on_a_VM_Warm-Cycle.xml
2 If necessary, create a directory.
3 Run Control Panel > Administrative Tools > Task Scheduler