User manual

Making Network Interface Cable Connections

BlackDiamond 8800 Series Switches Hardware Installation Guide

107

Figure 62: Connecting a 10G4Ca Module Port

To disconnect a cable from a 10G4Ca module:

1 Holding the cable connector with one hand, press it against the module front panel as you use the

other hand to pull back evenly on the latch (Figure 63).

Figure 63: Disconnecting a cable from a 10G4Ca port

2 Make sure the latch is pulled into the fully disengaged position.

3 Pull the cable connector straight off the port connector.

BD_157

BD_158