Specifications
Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.4.1 Release Notes
74
Resolved Issues in ExtremeXOS 12.4.1
The following issues were resolved in ExtremeXOS 12.4.1. The numbers shown in column one of the
following table are for internal reference and can be ignored. ExtremeXOS 12.4 includes all fixes up to
and including ExtremeXOS 11.1.4.4, ExtremeXOS 11.2.3.3, ExtremeXOS 11.3.4.5, ExtremeXOS 11.4.4.7,
ExtremeXOS 11.5.2.10, ExtremeXOS 11.6.5.3, ExtremeXOS 12.0.5, ExtremeXOS 12.1.3, ExtremeXOS 12.2.2-
patch1-8, and ExtremeXOS 12.3.3-patch1-4. For information on those fixes, see the release notes for the
specific release.
PD3-208178928 Adding a static route with an MPLS LSP may cause one of the following problems:
• If a static route is added with an MPLS LSP whose transport setting is “IP traffic
deny,” the route is displayed with an invalid nexthop in the show iproute mpls
command output.
• When a static route is added with an MPLS LSP that is not present in show
iproute mpls command output. For example, if there are 17 RSVP-TE LSPs to the
same destination, only 16 LSPs are eligible for carrying traffic because of a maximum
ECMP path limit of 16. Adding static routes with 17 LSPs results in the same
observation.
Spanning Tree Protocol
PD4-492384091 When scaled to the maximum number of Rapid Spanning Tree Protocol (RSTP) domains
with EMISTP port mode, an IGMP packet loops for a short period of time when a link
flap occurs.
Table 41: Platform-Specific and Feature PDs
PD Number Description
General
PD4-1168199957,
PD4-1156762929
A triggered IGMP query with the wrong 802.1Q tag is sent on a vMAN enabled port.
PD4-1131636749,
PD4-1099203316
Egress vMAN ACLs are not getting matched, even though the traffic matching the ACL
match condition is egressing the switch port.
PD4-1151118264,
PD4-931823732
A loop occurs after disabling learning on a protected VLAN on an EAPS master.
PD4-1147158779,
PD3-175211031
The ExtremeXOS CLI does not prevent EAPS health check PDUs from looping using the
permit all keywords when installing ACLs.
PD4-448603051 The unconfigure pim vlan command clears (unconfigures) an SSM configuration on
a VLAN but the VLAN continues to operate in the SSM VLAN, even after running the
disable pim and enable pim commands.
PD4-1125058997,
PD4-1111322167
When running the disable subvlan-proxy-arp vlan command on a subVLAN,
clients are not able to resolve the ARP request for the superVLANs interface IP address.
PD4-1110457330,
PD4-938840511
CPU utilization threshold cannot be cleared through SNMP.
Workaround: Run the disable cpu-monitoring command.
PD4-1084310235,
PD4-901582203
A typographical error exists in the following error message and will be corrected in the
next version of ExtremeXOS software:
<Warn:AAA.RADIUS.serverSwitch> MSM-A: Swith to server...
Table 40: Platform-Specific and Feature PDs (Continued)
PD Number Description