Specifications

Open Issues, Known Behaviors, and Resolved Issues

ExtremeXOS 12.4.4 Release Notes

Resolved Issues in ExtremeXOS 12.4.1-patch1-5

The following issues were resolved in ExtremeXOS 12.4.1-patch1-5. ExtremeXOS 12.4 includes all fixes

up to and including ExtremeXOS 11.1.4.4, ExtremeXOS 11.2.3.3, ExtremeXOS 11.3.4.5,

ExtremeXOS 11.4.4.7, ExtremeXOS 11.5.2.10, ExtremeXOS 11.6.5.3, ExtremeXOS 12.0.5,

ExtremeXOS 12.1.5, ExtremeXOS 12.2.2, and ExtremeXOS 12.3.4. For information on those fixes, see the

release notes for the specific release.

SNMP

PD4-1273682211 In SNMP MIB, the "SlotType" variable does not support all the card types on an Extreme

device.

Spanning Tree Protocol

PD4-1283017629 In some cases, STP ports stay in the blocked state in all the protected VLANs in a

specific domain, even though the output of the show stpd < domain-name >

ports command shows the state as forwarding.

PD4-1237283706 An MSTP port may stick in the listening state after a switch reboot.

PD4-1179902351 A "new root" trap is always generated when a link up or link down occurs on an edge

safeguard port on an MSTP domain.

Table 55: Resolved Issues, Platform-Specific and Feature PDs

PD Number Description

General

PD4-1301482701 ELSM is not responding after rebooting a switch, resulting in the links of neighboring

devices staying down.

Workaround: After rebooting the switch, run the enable elsm ports <port-list>

command again.

Summit Family Switches

PD4-1277806041 An ACL applied to another VLAN is matched even though the ACL is not applied on the

ingress ACL.

MPLS

PD4-1375779654 MPLS next hop is not being programmed in hardware on a BlackDiamond 20800 series

switch that is configured with static routing.

Workaround: Run the configure mpls ldp advertise static none command.

Multicast

PD4-1299398378 IPv4 multicast entries are not cleared after an IP multicast snooping entry times out

when add-ring-ports is enabled.

QoS

PD4-1256063039,

PD4-1142795366

Configuring a QoS profile for all ports using the all keyword fails if load-sharing is

configured on the switch.

Table 54: Resolved Issues, Platform-Specific and Feature PDs (Continued)

PD Number Description