Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.4.4 Release Notes
62
Open Issues
Following are the open issues for supported features in ExtremeXOS 12.4.4. They are organized into the
following sections:
Table 39: Open Issues, Platform-Specific and Feature PDs
PD Number Description
General
PD4-1947340095 DHCP/BOOTP relay does not work properly if iproute mpls-next-hops is enabled
because they are unsupported features.
PD4-1909431762 The debug eaps check configuration command does not return a warning if a
VLAN is not protected but has EAPS ring ports.
PD4-1933942563,
PD4-1935115266
Load script fails to enable routing protocols when an IP Duplicate Address Detection
configuration is on in the loaded configuration.
PD4-1937692011 Copying large configuration files through SCP fails.
PD4-1837408307,
PD4-1445926371
A link flap occurs on fiber links connected to a Summit family switch when a
BlackDiamond 10800 series switch is rebooted with ports disabled.
PD4-1206004841 The message displayed while upgrading firmware should read:
Firmware installed successfully will only be used on next reboot
PD4-935914533 Performing a ping test to a local but non-existent host results in an inconsistent
"Destination Host Unreachable" return message.
PD3-57182431 For the incoming traffic with alignment errors, the "RX Align" counter in the output of the
show ports <port number> rxerrors command is not incremented. Instead the
"RX CRC" counter is incremented.
PD4-813961562 When a service VLAN is changed to include a dot1q tag on both sides in CFM VPLS, the
RMEP entry is not learned on one side.
PD4-1101165057,
PD4-770508534
If the configure ip-mtu command is configured on VLANs that have only an IPv6
address, the show configuration command does not display the output for the
configure ip-mtu command.
PD4-1194741135 setDynamicAc.pl, which is used to create a dynamic ACL and bind it to a specific port, is
not working.
Workaround: The following SOAP element corrects this issue.
SOAP::Data->name("applicationName" => "Cli"));
PD4-910088928 The following error message is displayed when downgrading a switch from ExtremeXOS
12.3 or later to ExtremeXOS 12.2 or earlier.
Error: child process exited abnormally.
PD4-749060484 Errors are seen when a configuration having identifiers (SNMPv3 user name/EAPS
domain name) with special characters are loaded through a script.
PD4-561358261 If you create a super VLAN and a sub-VLAN in different virtual routers you are able to
bind the VLANs. Super VLANs and sub-VLANs should belong to the same virtual router.
PD4-460892051 Installing different versions of an ExtremeXOS image and an SSH image displays the
following error message:
Failed to install image- cannot read spec file" in the log
"upgrade failed installation:got error from installer DLL"
PD3-132508261 When issuing the enable jumbo-frame port all command on a BlackDiamond
8800, the MTU size for the VLAN is not configured. Sending 5,000 byte traffic works
correctly. However, if you disable jumbo-frames on the egress port the error message
Packet too big is displayed.