Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.4.4 Release Notes
107
PD4-962772436,
PD4-852494655
With CLEAR-Flow enabled, CLEAR-Flow ACL threads may be killed by EPM.
PD4-983613148,
PD4-670315790
When configuring egress ACLs on a load-shared port the following incorrect error
message is displayed:
Duplicate ACL config, Note: Egress ACL need be applied on the
Master port only
BGP
PD4-1142713461,
PD4-1108149831
The Route Manager crashes when a VLAN through which a network is configured goes
down when using the configure bgp add network command.
PD4-486115891 A Border Gateway Protocol (BGP) speaker is not advertising the inactive multicast routes
when they become active.
DHCP
PD4-1101780701,
PD4-727955846
DHCP OFFER and DHCP ACK packets are duplicated in a VLAN aggregation setup if a
DHCP request is received on a subVLAN.
PD4-804570175,
PD4-717000351
An error message should be displayed when adding a subVLAN to a superVLAN if
DHCP client or BOOTP client is enabled on the subVLAN.
EAPS
PD4-826755051,
PD4-682475164
IPv6 neighbor discovery packets sent to the CPU are affecting EAPSv2 PDUs, resulting
in the following message:
EAPS Shared Port: Segment timer expired.
PD4-874500533,
PD4-861919266
Expected traffic convergence time for EAPS has increased after upgrading from
ExtremeXOS 11.6 to ExtremeXOS 12.0, resulting in more traffic loss.
PD4-825283110,
PD4-627092945
When a shared port is configured prior to enabling an EAPS domain, the EAPS
protected VLAN does not block the secondary port in some cases.
PD4-976632991,
PD4-861919266
Expected traffic convergence time for EAPS has increased after upgrading from
ExtremeXOS 11.6 to ExtremeXOS 12.0, resulting in more traffic loss.
ESRP
PD3-52741820 Disabling a shared port results in the ESRP port restarting and the configuration
disappearing.
PD4-817417119,
PD4-631761683
When ESRP is disabled, clients using an ESRP virtual IP address as a default gateway
are not able to communicate outside the VLAN.
PD4-856338603,
PD4-729030981
A port restart occurs on ports that are enabled for ESRP port restart, even though an
ESRP state change has not occurred.
PD4-950113977,
PD4-740925847
The following error message is displayed in the log when adding ports to an ESRP slave
VLAN.
<Crit:vlan.err.criticalInfo> MSM-A: Critical Info:
sysctlWriteSetting: cannot open file.
IGMP
PD4-931233151,
PD4-926340897
Even with IGMP proxy enabled, when an IGMP subscriber leaves, the IGMP-leave is
forwarded with multiple subscribers on one port.
Table 57: Resolved Issues, Platform-Specific and Feature PDs (Continued)
PD Number Description