User`s manual

Anritsu User’s Manual - Page 3 of 13.
2.2 Configure Summit WMScanner
From the Summit WMScanner menu, select “Measurement Survey”, “Record
New Data…”, choose the “Anritsu Site Master / MS2711 / MS2711A / S33XB / S33XC”
item from the “Select Measurement Mode” box located at the bottom of the dialog, and
then click “Next >>”. This will open the Configure Serial Port dialog box shown in
Figure 1.
Figure 1: Configure Serial Port dialog box
Referring to Figure 1, select the appropriate serial port number where the Anritsu
HHSA is attached (e.g., COM1, COM2, etc.) The baud rate should be 9600. The other
settings are grayed out because the HHSA does not support any other modes different
from those shown in the dialog box. After these have been accomplished, click OK and
the Anritsu MS2711 HHSA options dialog box shown in Figure 2 should be presented.