User`s manual

Anritsu User’s Manual - Page 12 of 13.
recorded. All frequencies are given in Hz, and the bandwidth settings use an integer
index into the list of valid values (see the Anritsu MS2711 user’s manual for more
information). For all valid sweeps, 400 data points must be recorded. The sweep data
follows the aforementioned settings and parameters. Values are given in dBm and stored
as floating-point numbers with three digits following the decimal.
If power monitor measurements are being made, there are no settings or
parameters to be stored, and so only the power level is recorded. The singular data point
is stored in dBm using a float-point representation with three digits following the
decimal.
EXAMPLE:
1893.29 366.44 1.80 1 -72.444
1958.99 338.21 1.80 2 -71.852
2035.55 352.32 1.80 3 -71.804
X Coordinate Y Coordinate Z Coordinate
Type
REAL REAL REAL
Range
Floating point
number with
precision to 2
decimal
places; units
are in meters
Floating point
number with
precision to 2
decimal
places; units
are in meters
Floating point
number with
precision to 2
decimal
places; units
are in meters
Units
METERS METERS METERS
Required
Field
Yes Yes Yes
Example
34.24 -0.74 1.80
Continued:
MARKER
NUMBER
CENTER
FREQUENCY
(OPTIONAL)
SPAN FREQUENCY
(OPTIONAL)
INTEGER INTEGER INTEGER
1-32767 100000 to
3000000000
0 and 5000 to
3000000000
Hz Hz
Yes Yes in Spectrum
Analyzer mode.
No in Power
Monitor
Yes in Spectrum
Analyzer mode. No in
Power Monitor
1 900000000 5000000