User`s manual

Anritsu User’s Manual - Page 11 of 13.
EXAMPLE:
Tx1 2412.3
Tx2 2420.1
Tx3 2407.8
BASE STATION
NAME
FREQUENCY
Type
STRING REAL
Range
Any valid base station
name contained within a
drawing.
Floating-point number with
precision to 1 decimal place;
units are in MHz
Require
d Field
Yes Yes
Units
NONE MHz
Exampl
e
Tx1 2412.3
Data Heading Line 1 [Line 11]
Line 11 of the WVC Logfile gives the column headings for the data that follows
The end of line is designated by a standard carriage return/line feed. Line 12 is specified
as a string of underscore ‘_’ characters.
EXAMPLE:
X Y Z MARKER FREQUENCY (Hz) SPAN (Hz) RESOLUTION
BW VIDEO BW REFERENCE LEVEL DB DIV NUM POINTS SWEEP (dBm)
Data Column Headings
Type
STRING
Range
1 – 128 characters
Required
Field
Yes
Example
X Y Z MARKER
FREQUENCY (Hz) SPAN (Hz)
RESOLUTION BW VIDEO BW
REFERENCE LEVEL DB DIV NUM
POINTS SWEEP (dBm)
New Measurement Marker Data [Line 13 and greater]
Beginning with the thirteenth line of the logfile in this example and continuing
through the end of the file, actual measurement data will be found. All information in
this section of the file is tab delimited, using a separate row for each measurement
marker. The X, Y, and Z locations within the drawing are indicated as the first three
floating-point values. The marker number is then given as an integer, and the rest of the
data stream follows.
If a spectrum analyzer sweep is being performed, then the settings used on the
spectrum analyzer are recorded next, including center frequency, span, resolution
bandwidth, video bandwidth, reference level, dB/division, and the number of points