User guide

Summit WMScanner Users Guide 117
.
Verifying Network Coverage
On the Visualization panel, there will be a list of all the MAC addresses that were detected in the
measurement runs loaded in the drawing. If you select only the MACs in the list that are a part of your
network’s infrastructure, then the resulting grid shows the Network Coverage for only your access
points.
Identifying and Locating Access Points
Use the following steps to locate an access point:
1 Select one of the MACs in the list on the Visualization panel.
2 Change the lower signal limit to result in a grid that shows only the areas with higher signal
coverage.
3 Click on the Refresh button.
4 Repeat steps 2 and 3 until you have a grid coverage that is tightly centered around a small area: