User guide

Configuring the Altitude AP
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
76
3 Click the Static Configuration tab.
4 Select one of the VLAN settings for the Altitude AP:
● Tag ge d - VL A N I D – Select if you want to assign this AP to a specific VLAN and type the value
in the box.
● Untagged – Select if you want this AP to be untagged. This option is selected by default.
WARNING!
Caution should be exercised when using this feature. If a VLAN tag is not configured properly, the connectivity
with the AP will be lost. To configure the AP VLAN, do the following:
Connect the AP to the Summit WM series switch or to the network point that does not require AP VLAN tagging.
Use Static Configuration to enable VLAN and define the VLAN ID.
Save the configuration on the AP. The AP reboots and looses connectivity to the Summit WM series switch.
Disconnect the AP and attach it to its final network location.
If the VLAN settings match the network configuration, the AP registers with the Summit WM series switch
successfully. If the AP VLAN is not configured properly (wrong tag), connecting to the AP may not be possible.
To recover from this situation, you will need to reset the AP to its factory default settings. For more information,
see “Resetting the AP to its factory default settings” on page 207.