User guide

Configuring the Altitude AP
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
64
8 Click Add Altitude AP. The Altitude AP is added and registered.
When an Altitude AP is added manually, it is added to the controller database only and does not get
assigned.
9 Click Close.
Modifying Altitude AP settings
Altitude APs are added with default settings, which you can adjust and configure according to your
network requirements. In addition, you can modify the properties and the settings for each radio on the
Altitude AP.
You can also locate and select Altitude APs in specific registration states to modify their settings. For
example, this feature is useful when approving pending Altitude APs when there are a large number of
other Altitude APs that are already registered. From the Access Approval screen, click Pending to select
all pending Altitude APs, then click Approve to approve all selected Altitude APs.
Modifying an Altitude AP’s status
If during the discovery process, the Summit WM series switch security mode was Allow only approved
Altitude APs to connect, then the status of the Altitude AP is Pending. You must modify the security
mode to Allow all Altitude APs to connect. For more information, see “Security mode” on page 60.