User guide

Configuring the Altitude AP
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
62
To define the discovery process parameters:
1 From the main menu, click Altitude AP Configuration. The Altitude AP screen is displayed.
2 In the left pane, click WAP Registration. The Altitude AP Registration screen is displayed.
3 In the Security Mode section, select one of the following:
● Allow all Altitude APs to connect
● Allow only approved Altitude APs to connect
The Allow all Altitude APs to connect option is selected by default. For more information, see
“Security mode” on page 60.
4 In the Discovery Timers section, type the discovery timer values in the following boxes:
● Number of retries
● Delay between retries
The number of retries is limited to 255 in a five minutes discovery period. The default number of
retries is 3, and the default delay between retries is 1 second.
5 To save your changes, click Save.
Once the discovery parameters are defined, you can connect the Altitude AP to a power source.