User guide

Configuring the Summit WM series switch
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
48
Ensure that the OSPF parameters defined here for the Summit WM series switch are consistent with the
adjacent routers in the OSPF area. This consistency includes the following:
● If the peer router has different timer settings, the protocol timer settings in the Summit WM series
switch must be changed to match, in order to achieve OSPF adjacency.
● The MTU of the ports on either end of an OSPF link must match. The MTU for ports on the Summit
WM series switch is defined as 1500, in the IP Addresses screen, during data port setup. This
matches the default MTU in standard routers.
To set OSPF Routing Global Settings on the Summit WM series switch:
1 From the main menu, click Summit Switch Configuration. The Summit WM series switch
Configuration screen is displayed.
2 In the left pane, click Routing Protocols. The Static Routes tab is displayed.
3 Click the OSPF tab.
4 From the OSPF Status drop-down list, select ON to enable OSPF.
5 In the Router ID box, type the IP address of the Summit WM series switch. This ID must be unique
across the OSPF area. If left blank, the OSPF daemon automatically picks a router ID from one of the
Summit WM series switch’s interface IP addresses.
6 In the Area ID box, type the area. 0.0.0.0 is the main area in OSPF.