User guide

Working with the Summit WM Series Spy
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
190
Viewing the Scanner Status report
When the Summit spy is enabled, you can view a report on the connection status of the RF Data
Collector Engines with the Analysis Engine.
To view the Summit spy scanner engine status display:
1 From the main menu, click Summit Spy. The Summit Spy screen is displayed.
2 Click the Scanner Status link. The Scanner Status report is displayed, as shown in the example
below.
The boxes display the IP address of the Data Collector engine. The status of the Data Collector engine is
indicated by one of the following colors:
● Green – The Analysis Engine has connection with the Data Collector on that Summit WM series
switch.
● Yellow – The Analysis Engine has connected to the communication system of the other controller,
but has not synchronized with the Data Collector. Ensure that the Data Collector is running on the
remote controller.
● Red – The Analysis Engine is aware of the Data Collector and attempting connection.
If no box is displayed, the Analysis Engine is not attempting to connect with that Data Collector Engine.
NOTE
If the box is displayed red and remains red, ensure your IP address is correctly set up to point to an active
controller. If the box remains yellow, ensure the Data Collector is running on the remote controller.