User guide

Working with third-party APs
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
176
4 Connect the third-party access point to this port, via a switch.
Step 2 – Define a WM-AD for the third-party AP port:
1 From the main menu, click WM-AD Configuration. The WM-AD Configuration screen is displayed.
2 In the left pane, type a name that will identify the new WM-AD in the Add subnet box, and then
click Add subnet. The name is displayed in the WM Access Domains list. The Top o lo gy tab is
displayed.
3 In the Assignment by drop-down list, click SSID.
4 To define a WM-AD for a third-party AP, select the Use 3rd Party AP checkbox.
5 Continue configuring your WM-AD as described in “Configuring topology for a WM-AD for
Captive Portal” on page 98.
NOTE
Bridge Traffic at AP and MAC-based authentication are not available for Third Party WM-ADs.
Step 3 – Define authentication by Captive Portal and RAD policy for the third-party AP
WM-AD:
1 Click the Auth & Acct tab.
2 In the Authentication Configuration screen, click Configure Captive Portal Settings.