User guide

Availability, mobility, and controller functionality
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
168
To enable and configure Check Point:
1 From the main menu, click Summit Switch Configuration. The Summit Switch Configuration
screen is displayed.
2 In the left pane, click Check Point. The Check Point Configuration screen is displayed.
3 To enable check point logging, select the Enable Check Point Logging checkbox.
4 Type the following information:
● Check Point Server IP – Specifies the IP address of the ELA Management Station
● ELA Port – Specifies the port to use for ELA. The default port is 18187.
● ELA Log Interval – Specifies the amount of time (in milliseconds) you want the system to wait
before attempting to log once there is a connection between Summit WM series switch and the
Check Point gateway. The default is 100 milliseconds.
● ELA Retry Interval – Specifies the amount of time (in milliseconds) you want the system to wait
before attempting a re-connection between Summit WM series switch and the Check Point
gateway. The default is 2000 milliseconds.
● ELA Message Queue Size – Specifies the number of messages the log queue holds if the Summit
WM series switch and the Check Point gateway become disconnected. The default is 1000 log
entries.
● SIC Name – Specifies the Secure Internal Communication (SIC) Name, your security-based ID.
● SIC Password – Specifies your Secure Internal Communication (SIC) password. You can use the
Unmask button to display the password.
5 To save your changes, click Save.